ULTIMAKER ORIGINAL +
Tailored for limitless creativity
The Ultimaker Original+ is the new and improved version of the already impressive Ultimaker Original! This classic favorite comes as a refined DIY kit that offers excellent features that can rival any desktop 3D printers on the market right now.

The Ultimaker Original was rated as the most accurate and fastest 3D printer by Make Magazine. This upgraded version is built on the existing platform with the added advantages of:
-
Heated glass print bed - better adhesion, effortless part removal, and smooth bottom surface!
-
Improved Z-stage - stable print bed construction for improved accuracy
-
New and improved electronics for reliable temperature control
-
New fan duct design
-
UltiController included - easily control and monitor your printer
It is capable of producing very fine layer resolution (up to 20 microns) and uses open filament system which allows you to experiment with many new and innovative filaments available on the market.
Ultimaker's large international user community is always ready to share their ideas and knowledge, you can get useful resources and support from the community 24/7 and gain the best out of your Ultimaker Original+ 3D printer.
Whether you need a 3D printer for your workshop, home, or office, the Ultimaker Original+ DIY kit is right for you!
Features :
Layer resolution
up to 20 micron
Build volume
21(X) x 21(Y) x 20.5(Z) cm *(refer to the note below on build volume)
Position precision
X 12.5 / Y 12.5 / Z 5 micron
Print head travel speed
30 - 300 mm/s
Recommended filament diameter
2.85 mm
Nozzle diameter
0.4 mm
Stand-alone SD-card printing
Print technology
Fused filament fabrication (FFF)
Nozzle operating temperature
180° - 260°C
Heated bed operating temperature
50° - 100°C
*Note on build volume: The X and Y dimensions specified are representative of the maximum size you can print in the X and Y directions. It is not possible to print a cube of the specified build volume as you have to take into account clearances for the four retainer clips of the glass print bed. Other factors/ software settings including the use of skirt and brim will also reduce the overall build volume. Please kindly contact us if you have any questions regarding the build volume.
Software
Open-Source - Cura
Dimensions
W 35.7 / L 34.2 / H 38.8 cm
Filaments
-
Recommended materials: PLA and ABS
-
Recommended diameter: 2.85 mm
Temperatures
-
Ambient operating temperature: 15° - 32°C
-
Storage temperature: 0° - 32°C
Electrical
-
AC input: 100 - 240 V / 4 AMPS / 50 - 60 HZ
-
Power requirements: 24 V DC @ 9.2 AMPS, 221 watt max.
Warranty
-
12 Months* ( Please read our Terms and Conditions regarding Goods requiring Assembly)
-
* PTFE Coupler and Print Head Nozzle are consumable parts that will wear over time and are not covered under warranty. The frequency of replacement required for the PTFE Coupler or the Print Head Nozzle depends on the amount of usage and the types of filament used. Please kindly contact us if you need more information.